BMXmuseum.com Forums

BluWebco · RSS feed for topic

I decided on my next build, I would go low key - meaning less anodized parts, less bling, etc. I wanted to build a Schwinn cruiser that straddled the fence between something the Schwinn factory might have produced in the late 70's and a full out Cal Cruiser. So, here goes.

I started with a 1959 Schwinn Corvette frame, removed the kickstand, etc. and took it to my local powdercoater. Since this build was supposed to be half factory-like and half Cal Crusier custom-like, I decided to go with a color reminiscent of Schwinn's Sky Blue.

I had a set of Tange 1200 BMX forks which seem to be classic Cal Cruiser stuff, so they will be used. The headset is a combo from a Tioga Beartrap and a Peugeot Pipeline. I also polished out the headbadge to remove the paint. Here's where I'm at so far. Next up - gettin' the other parts & some fresh decals.

Here's what I started with -

FRESSTYLE FREEK · 2012-02-27 10:37am

looks good so far. I built a simler one. so I will watch and see what you do with yours.

83dback · 2012-02-27 11:52am

that's cool. subscribed.

JAMMJ · 2012-02-27 12:09pm

Heres a link on a 60' corvette with bmx parts on it.

http://www.cycleexif.com/road-kandy-custom

BluWebco · 2012-02-27 12:34pm

Been busy getting parts together and building wheels.

NOS Decals & silver ACS seat clamp

NOS silver KT Hubs

Arayas with KT hubs - need to clean up those spokes!!! :wink:

Porkchop Goodies

Takagi Cranks,NOS Blue Ano chainring, sealed YST bottom bracket conversion

BluWebco · 2012-02-27 12:38pm

Going with a chrome Schwinn single stem: Handlebar dilema - Original 1980 Schwinn Cruiser bars or Raleigh MX bars? I think I'll keep it "subtle" and use the Schwinn bars. Blue AME grips

Brooks Seat

26X 1.75 for a leaner look

Tioga 13/16 laid back NOS seat post arrived today, need to clean up some 9/16 KKT Silver road bike pedals, and need to purchase the chain.

Got something in mind for where the kickstand was.