BMXmuseum.com Forums

There was a thread the other day showing Redline Monster or Device cranks...don't know which, but that's what yours look like to me.

jkraig, quit following me around tonight....

Just kidding.

ps (Hope you're doing well!)

Soak the around the spindle area with a little wd 40 or PB blaster , let it sit a little while , then bop the spindle out using a mallett or a hammer using a board for cushion.   the spindle should push right out .   Then bop the cups and the bearings out same method from the inside out .  I use the back end of a wooden handled wire brush (toothpick size ) and it doesnt dent my bearings at all .    Its mainly just blastiing to soak and bopping parts out with those kind

crazy06 wrote:

the real radical wrote:

Soak the around the spindle area with a little wd 40 or PB blaster , let it sit a little while , then bop the spindle out using a mallett or a hammer using a board for cushion.   the spindle should push right out .   Then bop the cups and the bearings out same method from the inside out .  I use the back end of a wooden handled wire brush (toothpick size ) and it doesnt dent my bearings at all .    Its mainly just blastiing to soak and bopping parts out with those kind

thanks, just what i needed , 2 bad they are crap cranks

  I meant to say toothbrush size brush not toothpick    basically any strong wooden dowel or plastic ....Im sure you know what I mean from there . 

Group1 is a cool build to do