BMXMUSEUM.com Forums

ok, if i read correctly....

the collar goes inside the drop outs. the alloy washer and allen bolt goes outside the drop out,



see the collar ?


im using rockford bolts on my set up and brass washers..
yours would have the small alloy washer thing and the allen bolt here.


this is where the collar slides on to. the collars have a tiny set screw on them to lock them down.

chances are i may be telling you wrong because i dont know exactly what your setup is.
pics of your stuff would help.

Last edited by Draw (2009-11-03 11:47am)

bullseye collars slide. you use a tiny allen bolt to lock them down.

did you get the right sized axle for instance 110mm or 130mm

giginfrogg wrote:

did you get the right sized axle for instance 110mm or 130mm

oop,dont know,thet just came off a conventional old school bike,a ripper i think???im wanting to fit to a t.a

if the collars go inside the dropouts then no way are they gonna fit!!about 15mm to wide!!will get a pic up shortly

markyp wrote:

if the collars go inside the dropouts then no way are they gonna fit!!about 15mm to wide!!will get a pic up shortly

you need different sized collars then..and or axles..

be back in a mo chaps,gonna load up these pics

There is a way around! All we need is a concrete chisel, baby sledge, and a torch. Real easy.

haro hoodies ?

whats thet got to do with this ???



you pasted the wrong linky

lol,what a fook up,hang on!!haro hoodies!!!two secs!!

do they fit any of your other bikes? that looks like 145mm from here..

Last edited by giginfrogg (2009-11-03 12:38pm)

so what am i needing??differant size collars and axle too??