BMX Bikes / D / Dyno / 1985 Dyno Compe

1985 Dyno Compe
 

1985 Dyno Compe

F&F was build December of 1985

My Latest build.... This survivor F&F set was built up as a low cost rider. Most of the components are survivor condition parts with the exception of the tires, grips, brake cables, seat and chain ring. I always thought the quality of the materials and welds on these early Dyno's look just as good as the GT performers. I'm assuming the "lower end" status was due to the components that were on these bikes when they were sold as completes. This made me want to customize a Dyno Compe II, just like I did with all my bikes back in the day. The geometry feels very similar to my 84 Master. It's full 4130 Chromoly and It feels a bit lighter than my Haro. Hope you enjoy!


Frame & Fork ~ 85 DYNO COMPE (all original)
Rims ~ ACS Z-Rims (Mike Buff signature)
Front Hub ~ ACS Low Flange
Rear Hub ~ Bendix Coaster
Tires ~ Odyssey Frequency G (20X1.85)
Cranks ~ Tioga Task Force
Sprocket/Spider ~ Porkchop/Tioga CD
Pedals ~ Shimano DX type
Bottom Bracket ~ Tioga Beartrap 24TPI
Brakes ~ Dia Compe Nippon, Tech 4 Levers
Seat ~ New Dominator (Porkchop)
Seat Post ~ GT Layback
Seat Post Clamp ~ GT 
Bars ~ GT Performer
Stem ~ ACS 55 Slant (Diamond Back version)
Rotor ~ ACS
Headset ~ Tioga MX-2
Grips ~ Ame Tri's

Submitted by nealsky

  • Freestyle / Flatland
  • Company: Dyno
  • Model: Compe
  • Wheel Size: 20"
  • Toptube length: 18.5
  • Headtube size: 1"

View Cart →